Antec TriCool 92MM DBB Case Fan 3-SPEED 1200/1600/2200RPM 21/28/38CFM 14.6DBA W/ 3 & 4PINS

Comment:
Great fan, i attached mine to a VGA heatsink for my X1950XTX card. The 3 speed controller is great for the hot summers and cold winters when i dont need as much cooling. My only hope is that this fan lasts longer then the stock Antec fans i recieved with my case.

Comment:
Bought for use as a heatsink fan with the Thermalright XP-90 S478 S754 S939 92MM Aluminum Heatpipe Cooler. Attaches perfectly with the included fan clips with the heatsink. Currently using it on medium speed. At high speed it cools a lot more but it does get noisy.

Comment:
i replaced a ps fan with this bugger. works great - it has almost the same cfm as the original fan, but is less audible at the slowest speed.word from somebody: if you're replacing your ps fan to be quiet, make sure you don't starve it for air. most ps have thermally controlled fan speed - the stock fan speed can usually be found by searching its part number and make (on the sticker in the center of the fan) on google. the max fan speed is there so that you don't fry your ps or burn your house down.if i could have easily found the yate loon high speed 92mm fan, i would rather have bought it. this one works great though.

Comment:
I bought this fan because it was on sale for something like 3 or 4 dollars. I mean you can't really go wrong at that price. But also, the fact that it can run up to 2200 RPM and just bomb air into your case is really great. It's really helped cool down my system.

Comment:
Picked this little guy up for $6 on sale. With Antec quality and the double ball-bearings figured I couldn't go wrong. Move air nicely but not as fast as some others but for the price....still a good buy. When on sale, pick one up!

Comment:
good fan with adjustability, however the lowest setting is not quiet for those with a silent fetish. A fan controller to go even lower volts would be needed for those. Other than that this fan seems good with good bearing noise.

Comment:
Get one in my antec p150 at low speed and I dont hear it, magestic. But if you need a lot of cooling forget it beacause at high speed it's very noisy

Comment:
Nice fan, very pleasant and silencious in "low speed" mode, not as efficient as noctua or scythe in "high speed" mode but the speed adjustement button makes it quite practical, eventhough that same button tends to get into the way all the time.Its quite cheap, so if you don't want to spend 20$ on a 120mm fan, go for this one.The speed adjustment button lets you chose which speed you prefer, and unlike the auto-adjustable smartcool sensor it doesn't run the risk of getting broken and getting your fan stuck at high speed.

Comment:
C'est du Antec c'est déjà un bon départ. Double roulement à billes pour durabilité et fiabilité. Bon moteur contrôlable avec un sélecteur de trois vitesses. À basse vitesse environ la demi du débit de la grande vitesse mais très silencieux malgrés qu'à haute vitesse le bruit plus important n'est quand même pas si dérangant. Le contrôle de vitesse est fait par un sélecteur au bout d'un fil d'environ 4po ce qui permet de l'amener à une place plus facile d'accès que là où est le ventilateur. Payé $10 pas en vente c'est déjà un bon achat abordable. Meilleur rapport qualité/prix que je connais pour un fan de 92mm.

Comment:
92 mm is a weird fan size, but NCIX has these, and they are great fans, and they are cheap. You get the best of all worlds, so you can have a fast, high speed fan, or a slower quiet fan. It's a classy looking unit too, and it has legendary Antec quality... this one has dual ball bearings which is supposed to make it more quiet and improve longevity.

Comment:
Ordered this product to replace on my Thermaltake Sonata to fit on the side window of my case, and it works great! I have it on lowest level, which doesnt push the largest amount of air, but its really quiet which is why i replaced the side window fan in the first place. On medium level the noise is a tad bit more, but i didnt need the extra air. On high level, however, it is quite loud, especially for me since because it is a side fan the noise is really noticeable. The three speed control makes it really easy to handle and i'd definitely purchase another one of these if i had to.

Comment:
Seems to pump a lot of air! Some side panals only fit 92mm fans, this works great. I'M NOT GOING TO ENTER ANY MORE WORDS DAMN IT!

Comment:
One of the few 92mm fans out there. Good quaity and you can pack the speed setting to suit you noise/air flow requirements. Good qualityUnit is a bit noisy on high but I think most people will use it on medium/low anyway.Unlike the other Antec Tricools, this one does NOT have any LEDS. Strikes me as odd that it doesn't considering that its a clear housing and the 80/120mm tricools are LED....

Comment:
Bought 2 of these to put in the front of my Antec Solo case. This fan moves alot of air for the noise it makes. Sure, the high level is really noisy but low and medium level is more than enough.

Comment:
These see-thru fans look nice in an illuminated case like mine. Besides, the 3 speed setting is a useful feature. You do hear it at high, however I've got it set lower most of the time. Recommended.

Comment:
I bought 2 of these fans to mount in the front of my Antec Solo (read P150) case. They are set on medium and are barely audible. They move a good amount of air over my HDDs and keep things pretty frosty inside the case. I wish the speed control cables were longer as I could have modded an empty drive bay plate to control them from the front for serious gaming sessions. Overall a solid purchase though.

Comment:
The Antec Tricool fan is transparent and nicely designed. Fits the Antec Solo case perfectly in the front. The fan is quiet and the speeds are changeable. There is also a 3-pin connector to save a molex connector from reaching the fan area.

Comment:
This fan's pretty good for the money, I use it on the back of my case, It really cools my case temperature significantly. Would be nice if it did have some LEDs.

Comment:
I just got this yesterday and I love it. its much quieter than I thought it would be. This is the first antec fan I have bought, before I just bought cheap no name brand fans but I will never buy another one of those. Awesome little fan and cools my little sempy very well. System temps went from 37 degrees Celsius idle to 31 degrees Celsius idle.

Comment:
I really like Antec's TriCool fans. You can select from 3 speed settings depending on how much noise you want. They also cool very well. Also comes with a 3pin to molex adapter.

Comment:
I really like these tricools. The inbuilt fan speed controller really enables you to diagnose and adjust noise areas in your case. Highly recommended.

Comment:
Rather pricy for a 92mm fan but it works wonders. You can adjust the speed of the fan to get max air flow or get a quiet system. Recommended.

Comment:
I'd recommand this to anyone who's looking for 92mm Fan.This should be on ur very top of the list!

Comment:
This is a good fan, but I expected more bang for the buck. It is well made, the variable speed switch is great, but the CFM and dBA per dollar just isn't there.

Comment:
Good, quiet fan, I like the 3 position switch, length of power cable is good considering it's mounted on the removable side panel of my Antec case. Be nice if it had some LED's on it though :)