COOLER MASTER Megaflow 200 R4-LUS-07AR-GP Red LED Case Fan

Comment:
It moves a lot of air. I like the red LEDs that matched my case too. When it does move a lot of air, it didn't necessarily move fairly as a lot as I anticipated. My case is the HAF 922. I had 2 120s on the side and decided to replace them with this 200mm to see if I could get far more airflow at a quieter noise level. My case temps truly went up a couple of degrees, but got quieter. If you demand absolute maximum airflow, go twin 120s instead of a single 200. If you want a quieter case even though sacrificing a degree or two, go with the 200. That's my experience at least.

Comment:
Very quiet for the cfm you get from it, operates genuine good on the haf 922 ,not too bright either just best. none so far properly worth the cash

Comment:
Cools my HAF 922 extremely properly as an optional side chassis fan. Runs quiet as well. None really.

Comment:
The fan is quiet. It is sitting appropriate next to my monitor. The screws suck. Tried several phillips head drivers, nonetheless the screws stripped. I went to the hardware retailer and bought some manly ones and had no troubles. One other point, if your box is also a coller master, be conscious this fan doesn't present a wire to connect into the LED on/off switch. The fan is good, don't let the screws turn you away.

Comment:
Been a very good fan. Not loud and the red LED matches up in my HAF 922 case. I mounted as a side fan pushing air in and it performs good. None

Comment:
nice fan for 20$ , big , really quiet i recommanded it !!

Comment:
I got a handful of of these to fill in the empty spot in the top rated of my haf-x case and to replace the stock black ones. They all operate good and quiet, and the led's all match. nil i7 2600kasus maximus iv mobowin7 64xzalman cnps9900max cpu cooler16gig 1866hrz gksill3x evga gtx580 sc128gig plextor ssdcooler master haf-xall the extra fans/rheosmart six controller3 monitors 6140x1080

Comment:
It spins at about 973 rpm according to Speedfan. Performs as anticipated for my air cooling setup in the HAF 922 case. None.

Comment:
Awesome big ass fan, nice red glow and so quiet you can hardly hear it run.

Comment:
Operates, Straightforward, Rather, Simple to Install, Fits NONE for the fan. I just got the incorrect one particular. I want a bottom fan thats a little smaller sized. I mounted this 1 on the side door and it's great.

Comment:
A enormous fan that runs amazingly silent but nonetheless moves a lot of air. The red LED is a quite nice bold accent for my black case. A small pricey, but I really feel like the quality justifies the price tag. I personal a HAF 912 case, which only comes with two 120mm fans (one intake on the front and one particular exhaust on the back). I purchased one of these fans to use on the top rated opening (to replace the 2 120mm fans that I had installed) and currently saw a couple of degrees drop in my temperatures. I am quite pc literate when it comes to Working with them, but installing hardware is a lot more foreign to me. However, I was able to install this fan extremely effortlessly and comparatively speedily (moving the screws into the openings is difficult at initially, so make positive your philip's head screwdriver is the proper size so you don't strip the head of the screw). I plan to purchase one particular more to replace the front 120mm intake fan. Definitely recommend this!

Comment:
Bought it for my Cooler Master HAF X as the second upper exhaust fan. Worked great no issues as it should at this price point for a fan.

Comment:
Excellent size, mounts are adequate, super quiet. Moves a lot of air. I care barely hear it. The power cable could be slightly longer, but I had no dilemma. My case is really big, and had a lot of air holes on the side access panel. Working with stiff wire that bends effortlessly with your fingers or pliers but holds its shape nicely, I applied this wire to mount the fan. The fan is suspended about 1 " from the access panel inside the case vs being mounted directly on the access panel over the holes. My mounting strategy permits for far better airflow, plus the holes are conveniently directly over the motherboard/cpu. There is so much air flow I can really feel air coming out of other case holes, therefore a good pressure inside the case.I also bought A/C filter and mounted one more than the access panel air holes exactly where the fan pulls the air from, plus on the opposite side of the case access panel. Then I place some of the air filter media under the case exactly where the front bezel joins the case and had air inlet holes. I used double sided tape to hold the a/c filters.Immediately after 6 months of use, inside the case was fundamentally clean. Without the filter the inside would have b

Comment:
Nice fan that is very quiet and powerful.

Comment:
if you need a good 200mm fan get this one, you will be happy with it. but just a heads up if you have a haf 912 and a corsair h60 you will need to modify this fan to make them both fit

Comment:
This fan is silent for most purposes. There was no noise beyond what my HAF 922 had before I added the side fan. This also blows a wonderful deal of air and my situation temperatures are 3 degrees lower. My GTX 480 cards (dual in SLI) are no longer hot to the touch following I take off the side panel and my VReg is a total 6 degrees cooler. None that I am aware of. Maybe value and it should have come with the situation.

Comment:
It's a fan. It spins and blows air. Fits perfectly on the side of a haf 922. 20 bucks for a fan that ought to be included with the case anyway. I don't care for the light, but it's not quite bright and I hardly discover it.

Comment:
fits quite properly in an antec case fantastic replacement. it doens not snap in like the oem antec fan but four peices of double side tape will retain it from rattling/vibrating and the case cover hold it in place .does the job very effectively

Comment:
Love this Fan... It's large and it give me a lot of CFM cooling. I love the RED LED, it match my front HAF-X front case fan. Replace the 2 leading fan and the side...it provides me -5c better and the air flow are brilliant. I advisable this to everybody... I will upload video for this fan and my case....GOODLUCK None!!! Men and women say that this fan has no on/off wire like the one particular from the HAF932 or the sniper case for the LED switch... who cares...you bought this fan for show and for performance...why really should you care about the the on/off...all I can say.. if you dont like the the LED to be on all night.. you ought to bother purchase this fan...LOL...

Comment:
I purchased this to mount on my CoolerMaster 922 case and it fits completely. I just assume this fan was produced as an optional component to that case since it is identical to the front fan. It performs fantastic, is quite quiet, and the red illumination adds a great impact to the 922 case at night.No regrets... properly worth ฤ to add the further cooling. Get the 922 case if you are looking for a new one, superb air flow! None

Comment:
Fits as the second top mounted fan in my Haf X case.Glows RedIt's a fanIt moves air None but Its specifically the exact same fan that comes in the top mount of the Haf X case except this one particular glows red. It'd likely be greater to get two and replace the factory a single so they both glow.

Comment:
if you need a good 200mm fan get this one, you will be happy with it. but just a heads up if you have a haf 912 and a corsair h60 you will need to modify this fan to make them both fit

Comment:
Bought 2 of those for a cooler marter haf x full atx. I'm very satisfied coz I got them for haf prize. they look wonderfull but they could be brighter. love them coz they are low revolution low noise fan. I would purchase again

Comment:
Good air flow. I have all the fan's operating of the PS not the MB. Far better air flow and reduce temps on the GPU,CPU,MB.GPU 34CCPU 25CMB 25CI attempted operating the two exhaust fans off the MB. Temps were a lot higher. Only thought is equal air flow in and out?? Self taping screws. Without any trouble I striped 2 of the four screws putting in the fan. I purchased four bolts, four nuts and three rubber washers. Installed the fan back on to the side door. Really stable and a lot much easier to take the fan off to clean. Downside, nicely the bolts are not black. But I don't care... Quite low noise level. Over all a very good fan, even though it's a small pricey and I couldn't find one particular without having LED lights.

Comment:
very great case quite very good air flow lots of room took me much less than an hr to transfer all my build into case none this is the greatest case that i have discovered for quite nice air flow had it for more than a month and is incredibly good case