Koolance 4-WAY Brass Nozzle Body - Accepts 4 G1/4 Fittings

Comment:
I bought this 4 way piece to construct a tee fitting for my water cooling loop. I decided not to use a plastic tee since I was afraid it would leak or crack eventually. Solid piece and works quite well with two barbs and a quick connect for the draining hose.

Comment:
this is very useful in tight corner that is really hard to bend the tube... and its better than plastic... multi use function is a plus, you can use it as L or T or X depends on how you going to use it....

Comment:
this is very usefull i use it on my bottom rad inlet, i have 2 compression fittings in two inlets one coming from my gpu and the other going to a 10in of tube so i can drain my system with ease

Comment:
I bought this to replace both of my Bitspower plastic tees that cracked and began to leak. (never buying those again) It comes with the two stop caps in the picture so that is a plus. The only problem I had is that when 3 Bitspower 1/2" id compression fittings are used in a "tee" configuration the last fitting will contact the others and prevent the o-ring from sealing properly. All you need to do is to line up the fittings and file a small amount off at the contact points which will allow you to properly compress the o-ring on the last fitting.