Bitspower G1/4 High Flow 1/2IN Barb Fittings for 1/2IN ID Tubing
|
60%
0%
20%
20%
0%
|
 Rating: Review Date: 04/23/12 |
Bitspower G1/4 High Flow 1/2IN Barb Fittings for 1/2IN ID Tubing
Cons:The G1/4 Thread are very shortMy Thermal take Barb Fitting are 1/2 and there more safety
Pros:Nice Silver Finnish |
|
Rating: Review Date: 01/18/12 |
Bitspower G1/4 High Flow 1/2IN Barb Fittings for 1/2IN ID Tubing
Cons:non
Pros:Enfin quel que chose qui rentre bien avec le tuyeaux! Comment:
facile a installer et j'ai jamais u de perte d'Eaux ou bien une fuite. je vous conseil grandement se produit! pas chère et très efficace. |
|
Rating: Review Date: 05/09/11 |
Bitspower G1/4 High Flow 1/2IN Barb Fittings for 1/2IN ID Tubing
Cons:
None
Pros: Easy instalation, have multiple barbs unlike others with just one single barb Comment:
I used these on two GPU waterblocks ,EK FC460GTX and a RX360 rad. They work very well with my system and look great. I would recomend these without hesitation. |
|
Rating: Review Date: 04/27/11 |
Bitspower G1/4 High Flow 1/2IN Barb Fittings for 1/2IN ID Tubing
Cons:
not free...
Pros: they're shiny, they do not leak, easy to install, work well with zip ties. Comment:
i like these they really make it easy to install in to a rad or water block. they do not leak, they hold the tubing quite well, i used zip ties to clamp them and not one leak, the o-ring provided is built quite well. they cost less than compression fitings but they're just as good i think anyway. they come in a pair and they are great. |
|
Rating: Review Date: 07/29/10 |
Bitspower G1/4 High Flow 1/2IN Barb Fittings for 1/2IN ID Tubing
Cons:
short threads, weak material
Pros: they look nice Comment:
I bought a few sets of these for my new water setup. I was really excited for these bards are they are a company I trust, and saw a lot of good reviews. They showed up in good condition, when I installed them, and then started my 24 hour leak test in my bucket, one set leaked, even though it was very tight. So I drained the whole system, then took off my tubes, and started to gently tight them. as soon as I started to re tighten the threads broke. It was a good thing I had spares with better threads, and construction. |
Silver Finnish look great, but barb a bit short.