Power Up Black ATX Mid-Tower Case with 450-Watt Power Supply

Comment:
So case is so so sturdy, till you get components in it, my only issue is I got a 120mm fan, like it says it takes for the case but its a 90 or 92mm that goes there Love all the HD and 5.25 spaces!

Comment:
Nice case. It could have a better power supply. Would be more than adequate for the average user.

Comment:
Ok, so like most ppl have said the quality isn't as good as more expensive cases, but the biggest strong point of this is the price! Everything has worked great and I have no complaints. Mine runs very quiet, too.

Comment:
Decent buy, it was part of a barebone kit so i was stuck with it. The power supply seems decent enough and has been operating for about a month now without issue. The case is ultra light which says ultra cheap to me. But it serves it's purpose well. Not a lot of room, but enough for a basic computer. Avoid this one for higher powered machines.

Comment:
A decent case, complaints about it being flimsy are rediculous, what are they doing with their case? I read reviews about heat: Add a 90 mm fan in the rear and a 120 mm in the front and this case will stay cool, I have a AMD Phenom 9650 4 with a Cooler Master Hyper N520 CPU Cooler and I havent had its temperature go over 27 degrees celcius...

Comment:
Feels cheaply made to me, but performs its intended function. Not a whole lot of room inside, but enough for what I need it for.

Comment:
Great case, but if your not careful... it gets hot inside. you need better cooling in this little case

Comment:
As part of a Barebones kit the value was great. Had to remove plastic side vent in order to clear CPU cooler, rear insert for Biostar motherboard only stays in place once motherboard is screwed down, and the front audio connector doesn't quite reach so a bit of soldering will be necessary. Also the drive noise is amplified by the case...BUT...overall the kit does the job and for something that sits below the desk and I hope not to touch for another 4 years, I think it was a great buy. I plan on using another bare bones soon.

Comment:
What's up with all the bad reviews here? This is an inexpensive case for builders on a tight budget. This isn't a perfect case, but it's a standard case that gets the job done nicely. You can't beat this price for a case and a basic power supply.

Comment:
This really is the most basic of PC cases, its also rather flimsy and uses some of the thinest steel I've seen on a chassis. Also be warned if you are intending on using a tall heat sink (IE cm 212) you will have to cut a hole in the side panel to get it closed.

Comment:
I immediately noticed how cheaply it is built. Functional, but I have used paper that was stronger. This kind of quality gives our contry a bad name.

Comment:
I got this with a barebones kit and it has been great, love the size. Only 2 complaints had to modify the back panel to line up with the motherboard connectors and the big complaint is the power supply is noisy it actually makes kind of a pulsing sound dont know if its the fan or what. overall ok though.

Comment:
If you are like the guy that spends $200 on cooling and $40 on a case you WILL be dissapointed. However if you don't expect much for the $40 you might be quite happy.

Comment:
Case is a stripped down, but functional box, but very straightforward. My only real issue with it is that there is not quite enough ruum between the CPU socket and where the mount for the rear case fan is to go. My cpu cooler only left about three quarters inch.

Comment:
Very thin metal case. Compared to cases of a few years ago, this seems almost flimsy. The case did work just fine, and the power is good. Also nice looking when all put together.

Comment:
Its a cheap case, what do you expect. For the price its defiantly worth it. Some expected quality issues, sharp edges, no back slot covers that sort of thing. Overall not bad for the money.

Comment:
Amazing case. It looks great sitting on my desk. Everything in it is great, wide range of motherboards you can use in it. There are only two minor problems with it that are just inconvenient. First thing is the the power supply that comes with it could have more hook ups, it only comes with three. Second is the inclosing for you mobo on the back of it is a pain in the butt to get off. But other than those two things it is an amazing computer case.

Comment:
The cheapest made case I have ever owned! Got this case with Bare Bones Kit. The sheet metal is so thin and soft, it bent the side panel first time I opened it! ( Easy to bend back! ) Main Problem is noise! Cheap power supply sounds like a turbine running flat out! The rest of the case acts like a sound box amplifying hard drive noise! The case leads are also not long enough for some motherboards, I had to splice the front audio input leads to reach my motherboard! The bare bone kits are a good value, the case is not!

Comment:
Got this a part of a barebones package and had nothing but problems. - The motherboard back plate will not fit because the cutout was off. - The side panels will not fit correctly because the case is not correctly aligned. - location to put 3.5 HDDs is misaligned, widens as it gets towards the bottom. - not sturdy at all. I've made many DIY systems and this is without a doubt the worse case I've ever used. Only good thing is that it came with a 450-watt power supply.

Comment:
Pretty standard midtower case. Nothing fancy. A good one for the money.

Comment:
Lightweight, thin, so don't drop it! Was missing one insert from extension slots at back but that allows more air to circulate! NO Sharp edges on mine, once motherboard was installed, everything else fitted easily, cables were JUST the correct length for front connections - maybe 1 cm to spare! Good value for a basic box!

Comment:
first of all this case is cheap i found coke cans that dont crush as easy as this thing i bent the internal drive hanger frame when i mounted the cd rom, it bent so easy, the side bent when i took it off to mount my hardware, do not buy this thing pay extra for something better value is ok, seen better features are ok plenty of space but all the drives exceed the depth of the mounting rails it needs to be a tad deeper in fact my drives hang out over my MB and maby i am paranoid but when you go liquid cooling and spend 200 in case fans to make sure everything is cool last thing you want is a simple case that cant hold up quality just sucks big time as mentioned above with the dents in the side i had to do some alterations to get my heatsync to fit to where it doesnt touch so buy this at your own risk

Comment:
slim and attractive

Comment:
No problems with performance but I have a couple of small complaints. The case feels light weight and tinny compared to a Dell case. Why do the lights on after-market cases need to be so bright? If you fail to shut it down at night it will let you know by lighting up the room.

Comment:
Case with power supply worked great loved the light in the front. Hooked up very easy.