EVERCOOL HDAC Aluminum HDD Cooling Heatsink
33%
47%
7%
10%
3%
|
Thornton
Rating: Review Date: 10/23/11 |
EVERCOOL HDAC Aluminum HDD Cooling Heatsink
|
Meir
Rating: Review Date: 10/15/11 |
EVERCOOL HDAC Aluminum HDD Cooling Heatsink
Comment:
nice air flow keep my tough drive nice and cool stay at 78f to 79f. my other cool it all stay at 88f to 90f and run up to 116f with this on stay realy cool.not realy that loud at 3500 to 3600 rpm.i put the temp sensor on the motor drive.fit in my bay realy good not to big at all. had to drill hole to fit my tooless case. wish it had a air filter for dust and the sensor wire way to long. no book on it |
Trevina
Rating: Review Date: 08/26/11 |
EVERCOOL HDAC Aluminum HDD Cooling Heatsink
Comment:
cools tough drive display died following 6 months, but it was sufficient time so i know where to have the fan at to maintain HD cool. at high speeds the fan is rather noisy. will buy once more for next create if i can't find a far better remedy |
Darcie
Rating: Review Date: 08/07/11 |
EVERCOOL HDAC Aluminum HDD Cooling Heatsink
Comment:
WoksCools HDD by 10 degrease CelsiusFits in 5.25" bay perfectlycomes with necessary partsNOT DOA!Drive fits in securelyCan't hear a factor! Readout worked when, in no way worked once againsticks out a tad from coverRPM wheel does close to absolutely nothing Very good product, no noise, don't anticipate the readout to function, |
Tia
Rating: Review Date: 07/23/11 |
EVERCOOL HDAC Aluminum HDD Cooling Heatsink
Comment:
Sleek appear, basic design, straightforward install. There is hardly any other decent searching HDD cooling selections on the industry that give you the ease of use to view temp (Far/Cel) and fan RPMs. They make some noise when on high but nothing offensive, but you can hardly complain mainly because they cool my drives like champs. ྪ,000 RPM Raptors). Subsequent to no directions for install whatsoever. If it's your initial time installing a drive into a HDD cooler of this fashion I would appear on the internet for some instructions initial, basically the only factor to maintain in mind is spot the temp sensor on the spindle center on the bottom of your drive. I bought two at one time, one works great, the other blew out in about 6 hours. I expected this on the other hand because the potentiometer that controls the fan speed was installed reverse so that the high setting was low and vice versa. Just named newegg and explained scenario, sent me a replacement. Overall, these are fantastic devices that do the job of cooling your drives with ease of user interaction. |
I employed this to pull air into my case, not for a tough drive and I am very content. I have one fan at the top of my case, 1 in the PSU and one on the rear panel. I was not obtaining eoungh air circulation and this helped a fantastic deal. No instructions included in the box. I am happy with this acquire. Newegg did a good job as usual.